ipl-logo

Fiat 500 Case Study

963 Words4 Pages

17. Fiat 500 (1957): The city car of Fiat 500 was a rear engine, 2 door fastback and four passengers marketed and manufactured by the Fiat automobiles over the 1st generation of the station wagon and coupe body styles. They launched Most Reliable Cars of a new Nuova have been very cheap & practical touring car. There are originally measured in length of 2.97 meters and powered by the 2 cylinder 479 CC, air cooled motor and consider the 1st city cars of Fiat 500 just producing 13 horsepower. These Most Reliable Cars model featured with the fabric roof, rear folding like a Citroen 2CV rather than roof design. Thus three models have been featured with suicide doors and sport version of distinctive red stripe & powerful engine. It gives an original …show more content…

The Copper Brazed was also referred as CoBra“The Mighty Tin”. This car has been originally established by the Lloyd Taylor of engines in California. These Most Reliable Cars were used for military purpose in a abroad B17 flying fortress bombers and PT boats. It had been done to get uniform wall thickness, thin and avoided creation of the hot spots in the combustion chamber. Then the cars could ignite fuel and caused by pre-ignition, which was turned into limited compression ratio. These Most Reliable Cars engine has been used to refrigerator compressor, power generator and much more. They were widely used to praise for their effort of war succession. The CoBra car was a lightweight motor with one overhead camshaft & driven by the 2 sets bevel gears, small and front block of vertical shaft. The cylinder head and unitary block weight of only 6.7 Kg with complete all the accessory weights of 60 Kg. This engine displacement was 44 cubic inches that can produce the power to 26.5 horsepower and 20 KW at 5400 RPM. They could be acceleration from 0 to 60 MPH in 34 Sec, quarter mile drag time of 23.5 Sec, curb weight of 533 Kg and wheelbase 85 inches at a high top speed of 67 …show more content…

Thus the Prizm car was exclusively sold in the US and succeeded to the Chevrolet Nova. A unique model car of JV Company between the Toyota & General Motors in California was built in a New United Motor Manufacturing Inc. The Prizm car was replaced to the Pontiac Vibe that were related to Corolla & produced at NUMMI. This Prizm car was a four door sedan body type with the mounted on the front engine transferred power to the front wheels. These Most Reliable Cars was naturally aspirated engine capacity of 1.8 L, four cylinders with two valves per cylinder and a single overhead camshaft. This engine used a five speed manual transmission that can boost the power to 115 BHP, 117 PS, 56 KW at 5600 RPM and maximum torque of 156 NM at 4800 RPM. This car length of 172.6 inches, 66.3 inch width, 52.8 inch height, 97.1 inch wheelbase, 1070 Kg curb weight and compression ratio of 1.78. It was measured as a stroke of 85.6 mm, bore of 10.70 inches and stroke & bore ratio of 0.95. It could accelerate from 0 to 60 MPH in 10.9 Sec, estimated fuel and mileage consumption of 27/34 MPG at top- speed of 116

Show More
Related
973 Words | 4 Pages

The third reason is “ Chevy crew cab trucks had a parachute that deployed when released by chain”(Resses). This was the finishing touches of the Vehicles. General Motors was the smartest business for this in World War

Read More
1414 Words | 6 Pages

They put one of the big motors in the charger 500. A 440 magnum cid. They (NASCAR) banned the motor from the tracks because it was just too fast with a hemi. The Charger 500 was used in movies. Well know in the fast and furious movies.

Read More
697 Words | 3 Pages

The hypothesis was that the more mass a car has, the faster it will go. This hypothesis was partially rejected though. One reason that the car got slower on the last race could be because of wear and tear. It took awhile for the track to work properly. The end has a wall,and if the car hit it at the high speeds it was going, it may damage the car.

Read More
419 Words | 2 Pages

With 98 horsepower, improved from the previous version of the Spark, coming from a 1.4L engine, the Spark is zippier than before and eager to accelerate on the road or on the highway. Chevrolet promises a highway efficiency rating of 40 MPG. The standard transmission in the 2016 Chevy Spark near Mankato is a 5-speed manual transmission, but customers can also choose a Continuous Variable Transmission for smooth ratio-based gear shifts. Efficiency combined with the Spark’s small stature makes it a great urban car, able to

Read More
2146 Words | 9 Pages

The Camaro has more horsepower because its V-8 which has 295 horsepower and a bore of 4.00” x 3.48” stroke and 10.25:1 compression ratio, then the mustang with 230 horsepower 4.00” bore x 3.00” stroke and 10.0:1 compression ratio (Irvine 2014). The newer Camaros and Mustangs are faster and have more horsepower, but the Camaro is still faster because it comes with a supercharger and the mustang only has a flat-plane crank (Bell 2016). The Camaro has the potential to be faster because its lighter than the mustang. The 2016 Camaro’s weight is at 3,750 and the 2016 mustang is at 3,800 pounds, the Camaro can go 0-60 in 4.1 seconds and the mustang goes 4.4, and in a ¼ mile the Camaro runs 12.3 and the mustang goes 12.8 (Cleveland 2016). The 2016 V8 super sport (SS) Camaro is 390 pounds lighter, and made with alpha modular platform (Brauer 2015), which makes to car fun faster.

Read More
444 Words | 2 Pages

During the beginning of the war, horses and mules were indispensable for the moving of artillery. But as the war progressed, horses and mules became useless, and were extremely weak against the support of the enemy’s machine guns and barbed By 1914 motor vehicles were only used under limited field conditions. After realizing that horses and mules were useless in the war. They were mainly used for transporting weapons/artilleries because they were still helpful for transporting supplies and materials.

Read More
848 Words | 4 Pages

and I did a number on its underside. Whacked it up. Bent the tail pipe double. Rippled the muffler loose. By the time I was done with the car it looked worse than any other Indian car …” “Lyman just waited for Henry to notice, and it still took about a month” (397).

Read More
1422 Words | 6 Pages

Throughout the evolution of the track-wheeled vehicle during peace and wartime, there was one vehicle that combined the effectiveness of a large truck and a fully track-wheeled vehicle. The Half-Track was widely used during World War II on both sides of the lines. The Half-Track was highly versatile, making it the premier selection for the United States Army for nearly every function throughout the wars. There have been hundreds of uses of the Half-Track, including supply movement, crew movement, and anti-air protection. The effectiveness of the Half-Track as an all-purpose vehicle can be broken down into several areas.

Read More
772 Words | 4 Pages

• Cars how fast they go

Read More
481 Words | 2 Pages

TransFX incorporated had helped create this car. The car was created to be about 30 feet long, which is about the longest Batmobile ever, it is to have a single seat and tested to go about 140 miles per hour. Like the other car Ling had designed, the wheels and engine panel light up. The displays were much more involved with this car, however, with red, orange, yellow, and blue lights, as well as special pulsating lights in the counter-rotating turbine intake.

Read More
636 Words | 3 Pages

istory should stay as how it is and that all the symbols that are in place right now should stay where they are and no one should have the right to take them down or destroy them. People want to take down the statue of Robert E Lee, Also in world war on the ship that had a lot of power would be the uss patapsco because on the top of the iron ship it had a turret that could turn 360 degrees unlike the css Tennessee that had its weapons on the side. Robert e Lee and the ship both had power in the civil war. The use of power in “More than stones and symbols” and the fact of the uss Patapsco and the css tennessee is evident; however , the historical perspectives of each creator contrasting idea related to people believing and speaking out about whether we should keep the symbols of history and learn from them. These two sources show that we should learn from our history.

Read More
481 Words | 2 Pages

The bodykit is reduced and with larger air intakes on each of the front and rear are matched this car is to give an improved aerodynamic shape. His part again is an exhaust system, characterized by four retailers and sharp angles, obtained that make this car even in leaner look. She is proud to experience 19-inch wheels, the extraordinary movement in insight

Read More
1681 Words | 7 Pages

The current state of the automotive industry is one of shrinking margins, changing consumer expectations and demands, as well as pressure from the government to increase fuel efficiency. There is increased competition in the American market as foreign companies challenge the “Big Two” automotive manufacturers. Costs increase while the price for their products has remained stagnant. One way that manufacturers have managed to stay profitable is actively working to decrease costs while needing to keep the selling price the same in order to be competitive. The most successful ones have changed their relationships with suppliers to a partnership between the two companies.

Read More
755 Words | 4 Pages

This also gave the engine a 35hp/ton ratio. This was all sacrificed for greatly improved firepower. The tank itself weighs 11.5 tons, carries a crew of 3, has 6-13mm armor,400 hp, and a top speed 0f 72 km/h(45

Read More
2531 Words | 11 Pages

They started out with providing customer satisfaction, which was not the trend in automobile sector during those days. They are credit to have brought a revolution in the sector, to be the first company to be a mass production company, and sell more than a million cars in a year. The company has 2 manufacturing plants in Gurgaon and Manesar, which have a joint production capability of 1.5 million vehicles annually. A third plant is being proposed to be functional very soon in Mandal, Gujarat.

Read More

More about Fiat 500 Case Study

Related Topics

Open Document