Tn 4351 was originally isolated from bacteroides fragilis [30] . The transposon was successfully introduced into Cytophaga succinicans, Flavobacterium meningosepticum, Flexibacter canadiansis, Flexibacter strain SFI and Sporocytophaga myxococcoides by conjugation [25]. Tn 4351carries two antibiotic resistance gene. One of the codes for resistance to erythromycin and clindamycin which is expressed in bactroides but not in E.Coli. The other gene codes for resistance in tetracycline and is expressed in aerobically grpwn E. coli, but not in anaerobically grpwn E. coli or in bacteroides.
Isotopes of the same type will have a much more uniform weight. Despite these sources of error, the experiment was successful in representing the variations of the different isotopes of an
In this lab there were five different stations. For the first station we had to determine an unknown mass and the percent difference. To find the unknown mass we set up the equation Fleft*dleft = Fright*dright. We then substituted in the values (26.05 N * 41cm = 34cm * x N) and solved for Fright to get (320.5g). To determine the percent difference we used the formula Abs[((Value 1 - Value 2) / average of 1 & 2) * 100], substituted the values (Abs[((320.5 - 315.8) /
In the first part of the experiment, Part A, the standard solutions were prepared. As a whole, the experiment was conducted by four people, however, for Part A, the group was split in two to prepare the two different solutions. Calibrations curves were created for the standard solutions of both Red 40 and Blue 1. Each solution was treated with a serial 2-fold dilution to gain different concentrations of each solution.
The lab started off by measuring critical materials for the lab: the mass of an an empty 100 mL beaker, mass of beaker and copper chloride together(52.30 g), and the mass of three iron nails(2.73 g). The goal of this experiment is to determine the number of moles of copper and iron that would be produced in the reaction of iron and copper(II) chloride, the ratio of moles of iron to moles of copper, and the percent yield of copper produced. 2.00 grams of copper(II) chloride was added in the beaker to mix with 15 mL of distilled water. Then, three dry nails are placed in the copper(II) chloride solution for approximately 25 minutes. The three nails have to be scraped clean by sandpaper to make the surface of the nail shiny; if the nails are not clean, then some unknown substances might accidentally mix into the reaction and cause variations of the result.
Unknown Lab Report Unknown # 25 By: Jenna Riordan March 19, 2018 Bio 2843 1. Introduction Microbiology is the study of microorganisms found in all different environments throughout Earth, from the hot thermal vents at the bottom of the ocean to the ice at the top of a mountain.
For the Chemistry unknown lab, we were given unknown letter D. We decided the best way to approach the lab was to first determine whether our unknown is an acid, base, or salt. To figure this out, we made a decision to run a ph test. When our unknown was placed on the ph paper, the ph paper turned red which indicated it had a ph of 2. This ph meant our unknown was an acid.
From the experiment, the amounts of chlorpyrifos for three samples were identified. Based on the peaks, the retention times of the samples were between 6.711 until 6.714 minutes. The sample amount of standard was 30ppm. The response factor of the standard sample amount calculated for the standard sample was 11202 Hz s-1/s.
Leah Romero 10/30/2017 Conclusion Lab 3 Chem 102L In lab 3, fundamentals of chromatography, the purpose was to examine how components of mixtures can be separated by taking advantage of different in physical properties. A huge process in this lab was paper chromatography, which was used to isolate food dyes that are found in different drink mixes. The different chromatograms of FD&C dyes were compared to identify which dyes are present in each of the mixes.
Polyvinyl chloride is obtained by chain polymerization. Double bonds of vinyl chloride monomer get opened up. Since monomers possess a double bond between two of their carbon atoms in their structures, those get activated in the presence of tiny concentrations of starters. In this way, double bonds get open and monomers react rapidly so they associate with each other by forming macromolecules chains. Polyvinyl chloride polymerization is a highly exothermic reaction, where a high amount of heat is broken away (1525 kJ/kg).
CLAIRE MUNTING 29/01/2018 Criterion C EFFECTS OF SURFACE AREA OF CALCIUM CARBONATE UPON RATE OF REACTION Calcium Carbonate Chips 1 Introduction: Within the current investigation, the effects of the surface area of Calcium Carbonate (CaCO3) in combination with Hydrochloric acid (HCl) upon its rate of reaction. CaCO3, commonly referred to as limestone, is an organic substance and is, in a sense, the crystallised “carbonic salt” of the element, calcium2. In addition to being a salt, the pH level of Calcium Carbonate is 9.91, and it is therefore, a basic substance, due to the fact that it is comprised of a pH level higher than 7, which is neutral3. HCl, however, is the bodily acid found in the stomach of human beings.
Experiment #7: Column Chromatography of Food Dye Arianne Jan D. Tuozo Mr. Carlos Edward B. Santos October 12, 2015 Abstract Column chromatography is the separation of mixture’s components through a column. Before proceeding with the column chromatography itself, a proper solvent system must be chosen among the different solvents. The green colored food dye is the mixture whose components are separated.
INTRODUCTION A gas chromatograph (GC) can be utilized to analyze the contents of a sample quantitatively or in certain circumstances also qualitatively. In the case of preparative chromatography, a pure compound can be extracted from a mixture. The principle of gas chromatography can be explained as following: A micro syringe is used to inject a known volume of vaporous or liquid analyte into the head or entrance of a column whereby a stream of an inert gas acts a carrier (mobile phase). The column acts as a separator of individual or chemically similar components.
Introduction The goal of the experiment is to examine how the rate of reaction between Hydrochloric acid and Sodium thiosulphate is affected by altering the concentrations. The concentration of Sodium thiosulfate will be altered by adding deionised water and decreasing the amount of Sodium thiosulphate. Once the Sodium thiosulphate has been tested several times. The effect of concentration on the rate of reaction can be examined in this experiment.
Introduction The term chromatography actually means colour writing, and signifies a technique by which the substance to be examined is placed in a vertical glass tube containing an adsorbent, the different segments of the substance traveling through the adsorbent at distinctive rates of velocity, according to their degree of attraction to it, and producing bands of colour at different levels of the adsorption column. The substances least absorbed emerge earliest; those more strongly absorbed emerge later. (Wixom et al., 2011) In chromatography of all types, there is a mobile phase and a stationary phase.
